Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Programing a QSE-CI-WCI in a QSX system and Palladiom KP's to control a QSE-IO

  1. #1
    Junior Member
    Join Date
    Nov 2023
    Posts
    7

    Programing a QSE-CI-WCI in a QSX system and Palladiom KP's to control a QSE-IO

    Hello,
    I am trying to set up programming for an exhaust fan to be turned on and off by means of a Faradite 360 motion sensor.

    The gear being used is:
    Faradite 360 motion sensor with dry contact closure.
    QSE-CI-WCI wallbox closure input. Using terminals 1 & COM input for the Faradite sensor. QSE-CI-WCI is wired into the QS link on the keypad loop and has been activated.
    QSE-IO is used for the output closures to control a relay setup to control the line voltage of the exhaust fans. These have a separately derived 12-volt control through the contact closure to drive the relays.

    Now, first, in the programing of the QSE-CI-WCI device, I am having trouble understanding which assignable item to use here and which button type to select using the Faradite closure input.
    Second, when I am in the design tab the Faradite (third party occupancy) says “Not Assigned”. Is this because we would be just using the closure of it and not wired directly to a QSE-IO input?

    I am having trouble understanding how this should be programmed.

    Thank you

  2. #2
    Junior Member
    Join Date
    Nov 2023
    Posts
    1
    Wondering if you figured this setup and programming out. I have the same question and equipment and in the past with SeeTouch keypads I used the assign inputs to connect the motion but like you said with the QSE-CI-WCI there is no ability to assign them.

  3. #3
    Junior Member
    Join Date
    Nov 2023
    Posts
    7

    Easy

    Quote Originally Posted by John@CHE View Post
    Wondering if you figured this setup and programming out. I have the same question and equipment and in the past with SeeTouch keypads I used the assign inputs to connect the motion but like you said with the QSE-CI-WCI there is no ability to assign them.
    Yes.
    The Faradite won't get assigned. The WCI just gets programmed for an input "Maintained Contact Closure". The Faradite, even though it is a motion, doesn't get programmed as such. See this image. Hope this helps Click image for larger version. 

Name:	Screenshot (227).png 
Views:	10 
Size:	127.0 KB 
ID:	1138

Similar Threads

  1. Replies: 0
    Last Post: 11-29-2023, 09:51 PM
  2. Replies: 0
    Last Post: 11-29-2023, 09:38 PM
  3. Palladiom Wire-Free Shade system compatibility
    By SparkyCoog in forum General Discussion - Shades
    Replies: 7
    Last Post: 09-25-2023, 01:07 PM
  4. Can i control knx actuators using Palladiom Keypads and thermostats?
    By EkonX in forum 3rd-party Integration - HWQS
    Replies: 2
    Last Post: 07-20-2018, 04:51 AM
  5. ESN System to Control 4
    By Neoric in forum 3rd-party Integration - HWQS
    Replies: 1
    Last Post: 10-25-2016, 07:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •