Hello,
I have some lights, indoors and outdoors, some are manually turned on and some scheduled or scenes (sometimes vacation schedules) that have them on low dim like a night light.
Some of these same lights are also on a motion sensors, and I recognize I can set the motion sensor off level to the low dim instead of off.
BUT because I also use sunset to midnight and other timed schedules, I really wish the motion sensor (short duration control) would return the lights to PREVIOUS setting it was on when it overrides the existing level and turn off.
Of course with enough scheduling, it is possible to come close to desired illuminations.
What would be quite functional is in the Motion sensor programing dropdowns for each light , right next to the "unaffected" button would be a NEW button for "Previous" that would return it to previous setting.
i.e. Several Front Yard lights are on a 20% from dusk till 11pm. If motion during night turn on 100% for 5 minutes.....(then return to PREVIOUS; (20% till 11pm or off after 11pm)
If there are any other programing tricks for dual level or way to have the motion sensor trigger a scenes, I would appreciate the info.
Note I also have a fountain pump on a motion sensor and wish I could decouple off at dawn for light on same circuit, fixed this with a photocell, but would prefer SW or hardware sometimes.
thanks