Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: LED Strips Ghosting with Power Off at "NON DIMMER TYPE SWITCH"

  1. #1
    Junior Member
    Join Date
    Sep 2023

    Lightbulb LED Strips Ghosting with Power Off at "NON DIMMER TYPE SWITCH"

    My LED strips are Ghosting with a very low glow (Only seen in complete darkness) with the use of a standard 2 pole switch. These are not tied to any dimmer switches. They are wired correctly with X3 Daisy chained together. Nothing else is on the circuit as they are wired directly off the 200 Amp Gang box.
    Do You think installing the Shunt Capacitor (LUT-MLC) across the 1st LED strip will stop the glowing?
    Please advise.

  2. #2
    Lutron Technical Support
    Join Date
    Feb 2023
    Hello, what model of Lutron switch are you using in this application?
    Last edited by Kyle L.; 10-04-2023 at 05:00 PM.

Similar Threads

  1. Caseta Switches as "Mesh" or "Repeaters"
    By ambientdiode in forum General Discussion - CAS
    Replies: 2
    Last Post: 06-07-2023, 01:42 AM
  2. "TRANSFER" resets all occupancy sensors to "Enabled"
    By joshg in forum Programming - RA2
    Replies: 1
    Last Post: 11-07-2022, 09:21 AM
  3. LED Dimmer recommendations for a Dual Switch on a "designer" Faceplate?
    By KSHomeLighting in forum General Discussion - LED
    Replies: 2
    Last Post: 07-30-2021, 04:57 PM
  4. Connect Bridge goes from "Good" status to "Not Discovered"
    By jaysherwood in forum Troubleshooting - HWQS
    Replies: 6
    Last Post: 06-27-2021, 10:27 PM
  5. "Sivoia QS" versus "QED QS" & extending existing system
    By jfmartin in forum General Discussion - Shades
    Replies: 4
    Last Post: 09-27-2018, 08:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts