Hi, Hoping I can get some help for this wiring issue. I’m trying to remove a RA 2 dimmer switch (RRD-8ANS) from my Lutron system and replace it with a single pole Lutron Claro switch (CA-1PS). The dimmer has three terminals on one side (Black, Silver, Brass), a ground and a blue terminal which is unused. My confusion is what to do with the three wires + ground that attach to the dimmer switch as my single pole Claro only has two gold terminals + the ground. On the dimmer, there is a black wire attached to the black terminal and another black wire attached to the brass terminal. There is a white wire attached to the silver terminal which is between the black and brass terminals. What wires should go where on my Claro? Should I cap the white wire? Thanks for any help!