Primary Bath Switch Configuration

[dsporter10]

I'm finishing up a primary bath renovation and am trying to figure out the best way to configure my switches. In a perfect world, I would be able to operate each of these separately:

- 2 cans over the vanity + 1 over toilet
- 2 cans over the shower
- 2 lighted vanity mirrors
- LED shower niche
- LED toe kick (switch / motion?)
- 1 vent fan

Six switches on one wall seems excessive. I was hoping there would be a switch that could operate two lights separately, so I could consolidate some of these. Is there an easier way to do this that I'm not seeing?

Any suggestions or advice is appreciated!

[Brandon W.]

Hello!

Thanks for your inquiry. Currently, we do not offer a stacked switch in the Caseta family. Our apologies for this. You are welcome to remotely install a PD-6ANS on these loads and install a PJ2-4B-GWH-L21 at the wall box location, please refer to your local electrical code.



Alternatively, relay or dimming PowPaks can be utilized. These will install in a standard 4 in x 4 in junction box. Please note, these will not pair to the Caseta system. These will only pair standalone with the above-mentioned Pico remote. For dimming line-voltage lights, please utilize the RMJS-PNE-DV. For on/off, we recommend the RMJS-5R-DV-B.