Hello Lutron Community. Looking for some assistance on building a system using remote switches and tying two separate systems together
System 1 . I have 2 switches ( A and B ) that control 2 light sockets. A hallway type set up, a switch at each end, each switch turns both light sockets on/off.
System 2. 1 switch (C), 4 light sockets
I’d like to tie system 1 and 2 together and have switches (position A and a new position D) that turn on/off all 6 light sockets together. Old switch B and C can control all sockets as well but not a priority.
Note.. this is an older house and current switches are 2 wire (no ground). I was looking into the Caseta and Pico devices but not sure if that is the correct route.
Any help would be appreciated. Thanks!