Thanks Thanks:  0
Likes Likes:  2
Results 1 to 3 of 3

Thread: Extracting Old Project File

  1. #1

    Question Extracting Old Project File

    I understand you cannot extract a file prior to OS v6, but can I upgrade a v4 OS project to the current OS v9, and then extract, or is the limiting factor the OS version that created the project file, regardless of where it's at now?

    Basically, I went to go fix up a job that was done several years ago, saw the existing OS was 4.5, and am wondering if I should bother going down this road, or just go for broke and start from scratch, reprogramming everything. Thoughts?

    Thanks in advance,
    Andrew

  2. Likes Dimerize liked this post
  3. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    289
    Andrew, you can update the project file to a newer version but the firmware that is on the Main Repeater will not support the extraction. If you were to update the Main Repeater, it will erase any programming that is currently saved on the Main Repeater.

  4. Likes Dimerize liked this post
  5. #3
    Ok, thanks. So, it sounds like the only recourse at this point would be to start from scratch. It might take a long time to redo everything, so I want to make sure I'm not missing some quicker solutions along the way.

    Thanks again,
    Andrew

Similar Threads

  1. Corrupt project file
    By acculite in forum Troubleshooting - RA2
    Replies: 0
    Last Post: 09-07-2015, 03:24 PM
  2. Extracting project from 2 HW 8series interconnected
    By techniquesmethodes in forum Troubleshooting - Legacy HW
    Replies: 6
    Last Post: 06-19-2015, 09:50 AM
  3. Does extracting a file include homeowner edits by the app?
    By bloucks in forum General Discussion - HWQS
    Replies: 2
    Last Post: 04-07-2014, 08:29 AM
  4. Project file Extraction and Baud Rate
    By Armando B. in forum Troubleshooting - Legacy HW
    Replies: 1
    Last Post: 03-25-2014, 02:01 PM
  5. Extracting the XML
    By Ty W. in forum 3rd-party Integration - HWQS
    Replies: 0
    Last Post: 09-25-2013, 09:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •