Good morning guys. We are working on a project that was done originally done on QS and we are upgrading it to QSX.
Most of the existing Seetouch keypads are going to be replaced for Palladioms, but some of them are going to stay, and we are going to give them a facelift ordering new engravings and faceplates.
The customer wants the Palladiom's font on 14pt which only can be done online under myprojects.
However I couldn't find the choice for engraving there for the seetouch (Only for the International).
What is the correct approach for this?
Thanks in advance.