Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Occupancy sensor channel change LRF@-OCRB-P

  1. #1
    Junior Member
    Join Date
    Feb 2023
    Posts
    28

    Occupancy sensor channel change LRF@-OCRB-P

    I can't do these steps, I get to step 3, I don't understand steps 4 and 5.

    1 remove the battery from the sensor.
    2 replace the battery and within 5seconds press and hold:
    - test button,
    - ight button,
    - and one of the gray bbuttons on the back.
    3 hold for approximately 6 seconds until the dome stars to flash quicly.
    4 if the dome stops flashing before your sensor is on the correct channel, go back to step 1.
    5 press the light button repeatedly to cycle through the sensor's channels.
    6 when the sensor reachers the same channel as the link, a message will pop up.
    7 Close the pop-up.
    8 wait7 seconds, then press the test button to confirm that it is on the correct channel. The pop-up will reappear. if it doesn't, wait 7 seconds and try again.
    9 once the correct channel has been found, press and hold the following buttons for approximately 6 seconds until the dome stops flashing to save the channel and exit channel mode: -
    light button,
    -test button.

  2. #2
    Lutron Technical Support
    Join Date
    Sep 2020
    Posts
    103
    Thank you for your inquiry. To make sure we can help you the best way possible and collect more information about the steps you're following, we strongly encourage you to email support@lutron.com or give our team a call at 1-888-Lutron1. The channel change experience is an area where we have received feedback in the past and it's best followed live to help make sure the steps are going as expected. Thank you!

Similar Threads

  1. Can a change of airflow effect occupancy switches?
    By sfvalguy in forum Troubleshooting - Legacy Other
    Replies: 2
    Last Post: 12-08-2021, 02:48 PM
  2. 3 way vacancy sensor can’t change settings
    By Cg2000 in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 06-25-2018, 01:51 PM
  3. PLEASE Lutron: Timeclock & Occupancy software change
    By joshg in forum Programming - RA2
    Replies: 6
    Last Post: 03-29-2017, 09:36 AM
  4. LRF3-OCRB-P-WH occupancy sensor Operating during sufficient daylight
    By jwbcinergy in forum Troubleshooting - HWQS
    Replies: 0
    Last Post: 05-11-2015, 02:44 AM
  5. Can you change the RF channel in RA2 like you can in HomeworksQS?
    By GMHunt in forum General Discussion - RA2
    Replies: 1
    Last Post: 09-30-2014, 02:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •