Hello,
i keep getting an error message when i am transfering the program.
after 15 min i get to step 85 and the error message ''unlinked objects'' appears.
The complete lighting system is unresponsive and i will have to start the transfer again.
It can take up to 5 times of transering before it will pass the step 85.
I can see in the diagnostic tool that at the time the step 85 error appears the processor gets an reset with the following error:
Reset Cause: 20 (SOFT=1 WDR=0 POR=0 EXT=0 LOC=0 LOL=0) OSREV: 15.13.0
With kind regards,
Sander