I've replaced several 3 ways with a PD-5ANS in one box, leaving the toggle in the other box. No problems.
I'm on my last one and it is driving me CRAZY. The closest I can get it to working is that either/both the toggle and the Caseta will turn the light on - but the light shuts ITSELF off 1 second later! (Behavior is the same from both switches.)
At the toggle - I have the yellow jumper on the common screw and tied to the (white) incoming line and the black traveler, and the red traveler on the same side of the switch on a traveler screw at the bottom of the switch.
At the Caseta - green to ground, white to neutral in the box, blue to the red traveler, red to the load, black to the black traveler.
I ohmed out all the wires, so I have positively identified the line, load and travelers, and labeled them.
What I've tried -
- Switching the black and the red at the Caseta - no go
- Switched the bulb to a reg. incandescent just in case it was an LED problem. - no diff. - light goes on then off by itself.
- Replaced the toggle just in case of a bad switch - no diff. - light goes on then off by itself.
- Every permutation and combination of wiring swaps.
- Put everything back to normal - two 3 way toggles - works fine!
What's really bugging me is it is wired identically to the last 3 way I replaced - I've checked three times - and that one works fine.
I'm about to go to a 'smart' bulb in that fixture, but I hate to give up!
Can anyone help?
Thanks so much!