hey all ... I did a minor patio remodel and had an electrical contractor setup a ceiling light and connect it to a lutron HWD-6D dimmer switch that had been present for years.. but was never setup on my HW Illuminations system. But now with the new lights, I want to control it! I've programmed changes to the lighting many times.. but I'm failing to get this switch added and working.
Here's where I'm at...
Background: the original electrical contractor left 3 devices in my project not assigned... I've been seeing an error message on these 3 for ten years. These 3 devices are 2 dimmers and 1 on/off switch, all on my patio. One is the switch I'm trying to get working now.
IN THE SOFTWARE...
I've tried using the Address Assignment screen and the Serial Number Addressing wizard to get this to be identified... but I just haven't gotten the combination right yet.
What I *do* know:
- the switch is wired up and should be connected to the Link 4/H48 interface
- I have its serial # from a sticker
- when I try doing manual addressing and "triple click" it... the software reports "device ready for addressing" with the correct serial number and says the Wired Location is proc:1, link:4, H48:1 .. and bus 1.
BUT .. my project shows that the original system installers had these switches configured (in the address assignment screen) on bus 3 (3:1 and 3:6) but they never addressed these or put in the serial #.
Here's what I've tried
- Using Address Assignment screen to set it to Bus 3:1 (upload, run wizard.. no luck) and then after that set it to Bus 3:6 (repeat the same process). These haven't worked. in each case i go to the switch and triple tap ... I get an error message which says:
"the H48 device that was triple-tapped is physically wired to an H48 bus that has no unaddressed devices assigned to it in the project.
possible solutions include either moving the physical bus wiring on the H48 to match the project, or exiting Serial Addressing and moving the H38 devices to the correct bus on the Address Assignment screen."
I've also tried to locate this panel to see if I could identify where the wire is connected (the project says it's in the "pantry") but I haven't found anything.
SCREENSHOT of some of the settings attached!
THANK YOU FOR BEARING WITH A LONG EXPLANATION!
Do you folks have advice for me? :)