Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Programming a keypad button to cycle through 2 scenes with LED logic intact

  1. #1

    Programming a keypad button to cycle through 2 scenes with LED logic intact

    I have a 10 button keypad in a bedroom with 2 scenes (high, low). Next to the bed, I have another smaller keypad. I would like to program a single button on this keypad to toggle between (high, low), which I was able to do. The only issues is that the LED on the smaller button is always illuminated. The correct behavior should be illuminated in either (high, low) and off when the room is off.

    Any help would be greatly appreciated.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    If you create a manual sequence you can set the LED status for each step.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Programming a Ra2 switch or dimmer button like a keypad button?
    By AndyM in forum General Discussion - RA2
    Replies: 12
    Last Post: 04-02-2018, 09:14 AM
  2. Replies: 24
    Last Post: 10-30-2017, 08:30 PM
  3. Conditional Logic In Shared Scenes
    By michael.ce in forum Programming - HWQS
    Replies: 0
    Last Post: 12-05-2016, 11:29 AM
  4. Conditional Logic and Shared Scenes
    By t.reno in forum Programming - HWQS
    Replies: 3
    Last Post: 05-21-2015, 11:39 AM
  5. Keypad Button LEDs Tracking Different HVAC Scenes
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 02-12-2015, 12:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •