Hi All,
Was doing some testing with what I thought was a NOS TVM kit I had around. So far nothing out of the TVM outputs.
I was expecting to see either a solid or flashing "Data Ok", and in this case it's just off and the TVM leds are all blinking slowly. Any docs on the status LEDs for these? I feel like I've seen it but can't find anything at the moment.
Other than changing out the RPM harness is there anything I should check? It's a QS system running 15.5 with a MI, load was updated to 0-10V LED at 0W as described in "Using a TVM for 0-10V Control in HWQS – Rev C"
Assuming it's just a bad ISO2 that's been hanging around instead of being binned. Figured I'd ask here before condemning it and ordering a new one.
Thanks!