Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Troubleshooting 0-10V TMV Kit

  1. #1
    Junior Member
    Join Date
    Feb 2023
    Posts
    2

    Troubleshooting 0-10V TMV Kit

    Hi All,

    Was doing some testing with what I thought was a NOS TVM kit I had around. So far nothing out of the TVM outputs.
    I was expecting to see either a solid or flashing "Data Ok", and in this case it's just off and the TVM leds are all blinking slowly. Any docs on the status LEDs for these? I feel like I've seen it but can't find anything at the moment.

    Other than changing out the RPM harness is there anything I should check? It's a QS system running 15.5 with a MI, load was updated to 0-10V LED at 0W as described in "Using a TVM for 0-10V Control in HWQS – Rev C"
    Assuming it's just a bad ISO2 that's been hanging around instead of being binned. Figured I'd ask here before condemning it and ordering a new one.

    Thanks!

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    What kit are you using? Sometimes you have to specify sink vs source. Your device may be in sink mode meaning it is looking for changes in voltage from the source.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. MS-OPS5MH 3 way troubleshooting
    By Kashirat in forum Troubleshooting - Controls
    Replies: 2
    Last Post: 02-27-2021, 02:51 PM
  2. troubleshooting 3 way dimmerl
    By mmorningstar in forum Troubleshooting - CAS
    Replies: 2
    Last Post: 09-16-2019, 02:17 PM
  3. Keypad troubleshooting
    By Topher in forum Troubleshooting - Legacy HW
    Replies: 2
    Last Post: 08-07-2019, 03:39 PM
  4. Troubleshooting a Pico remote
    By mike123abc in forum Troubleshooting - RA2
    Replies: 0
    Last Post: 06-02-2018, 09:18 PM
  5. MI troubleshooting
    By Craig W. in forum Troubleshooting - Legacy HW
    Replies: 1
    Last Post: 08-19-2014, 01:06 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •