Hello, I tried to install a Claro switch today (DVRF-5NS) but can't seem to get it to work properly.
When I finish wiring everything up and turn the break back on, the LED on the switch and the light it controls immediately start flashing in a repeating pattern (on and off at about 0.5s intervals). This happens until I turn off the breaker again. Note that this is a flashing issue, not flickering. The light fully turns on and off each time.
I've triple checked all of my wiring, I'm connected to the neutral, hot, load, and ground. This isn't a 3-way setup, just a single bulb with one switch.
I've tried with three different bulbs, two of which were LED bulbs, and the third was an incandescent bulb, so I don't think it's an incompatibility issue, which is the only thing I can find if I search for other similar issues.
I've installed many other switches and dimmers in this house and another house, and this is the first time I've encountered anything like this. I'd appreciate any help, thanks!