AYCL-153P used with 6 high hats with 14 watts each. After working perfectly for a few years, this morning they stopped working. Not sure if they have an internal fuse or not. So, to start debugging I wanted to remove the live an neutral and cross them and see if the issue is the switch failure vs breaker or something in the high hat line once I validate the live was alive. I was about to remove the wires to twist and at the last second I wanted to short them through a piece of wire instead and as soon as I did that switch came back to life with no issues after the shorting wire removed. I have never seen this before with a lutron switch. So, is this an indication of switch is on it's way out and also is there a inline fuse or any means to reset this lutron switch without removing the wires. Thanks.