Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: ms-a102 occupancy switch mysterious green/yellow wire

  1. #1

    ms-a102 occupancy switch mysterious green/yellow wire

    There is a unusual green/yellow color wire coming out of the MS-A102 switch. The wiring diagram says to connect this wire to the ground.

    I'm guessing the green/yellow is basically the neutral wire for the device.

    If a neutral wire is available in the switch box, would it be better to connect the green/yellow wire to neutral?

  2. #2
    Senior Member
    Join Date
    Jun 2013
    Posts
    1,118
    Not sure what it is for, but I installed some of these in a bathroom without using the green/yellow. Lights would NOT turn off (and it's in the troubleshooting section). Attache the green/yellow to the ground and you'll be good.
    Business Development Associate- Design, Sales, Installation, and Programming of Smart Homes for Baker Electric Home Energy
    mbalay@bakerhomeenergy.com
    "Spread the light, brother" -Blake Richetta
    "If you think hiring a professional is expensive, wait until you hire an amateur" -Crustyloafer

Similar Threads

  1. Red/Green Flashing
    By hemmingsen in forum Troubleshooting - Shades
    Replies: 5
    Last Post: 06-10-2019, 09:28 AM
  2. Cable to Wire Repeaters
    By Armando B. in forum Design Assistance - RA2
    Replies: 8
    Last Post: 02-11-2015, 12:46 PM
  3. Passive infrared Occupancy/Vacancy sensor switch
    By tbone in forum General Discussion - Controls
    Replies: 1
    Last Post: 01-08-2015, 08:39 AM
  4. two wire switch no ground no neutral wires UMS-OPS6M-DV-WH
    By dfphoto in forum General Discussion - Controls
    Replies: 0
    Last Post: 11-21-2014, 02:10 PM
  5. Pre wire for shades
    By T1V1AK in forum Design Assistance - Shades
    Replies: 4
    Last Post: 02-21-2014, 07:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •