Thanks Thanks:  0
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Maestro wire connections.

  1. #1
    Junior Member
    Join Date
    Oct 2022
    Posts
    1

    Maestro wire connections.

    The Maestro motion censor has ground, 2 blacks, 1 green sleeved white.
    Coming out of the wall is ground, 2 backs, 1 red.

    Connecting the white to the red does not work.
    The light comes on but stays on. Will not go off. And I cannot program it.

    Any ideas what wire combination might work?

  2. #2
    Lutron Technical Support
    Join Date
    Jan 2021
    Posts
    127
    Would you be able to confirm which motion sensor you are using? It sounds like you are using the MS-OPS2. Also, would you be able to confirm if this is a single-pole or 3-way application? The two black wires and a red wire in your wall makes it sound like it's a 3-way setup. If this is a 3-way, you will need to use the MS-OPS5m.

  3. Likes randyc liked this post

Similar Threads

  1. TU-Wire Driver and Incandescent Load on Same Maestro Dimmer?
    By David C. in forum Design Assistance - HWQS
    Replies: 1
    Last Post: 05-11-2021, 03:10 PM
  2. Double checking on how to wire Maestro MACL-153M
    By boblite in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 02-14-2017, 04:15 PM
  3. RA2 Maestro Dimmer for Lutron Tu-Wire ballast
    By Dimerize in forum General Discussion - RA2
    Replies: 2
    Last Post: 02-05-2016, 06:38 AM
  4. Issues with remote connections
    By Corey in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 01-27-2016, 08:42 PM
  5. Maestro Controls - Solid Wire Only???
    By mark2457 in forum General Discussion - RA2
    Replies: 7
    Last Post: 09-05-2015, 08:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •