Hi all, I have a complex installation with several Caseta Pro hubs.
I have an issue in that all hubs are operating on the same RF channel and so when the channel is in use there is a delay until the channel is available.
I see that the RadioRA 2 system allows you to program an RF channel / frequency (https://www.lutron.com/TechnicalDocu...ary/048688.pdf)
And I see that the technical specs for the Caseta indicate the same range of frequencies are utilized 431 to 437 MHz (https://www.lutron.com/TechnicalDocu...e_Pro_Spec.pdf)
However, I've not yet found how to set the channel on the Caseta Pro hub to change from the default 0x1A 433.6 MHz
Has anyone come across this?
Thanks!