Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4

Thread: Homeworks QSX programming questions

  1. #1
    Junior Member
    Join Date
    Sep 2018
    Posts
    9

    Homeworks QSX programming questions

    I have a 3rd party motion sensor tied to the back of a 6 button keypad using contact closure and it is currently working to turn the load on and off.

    The client would like a keypad button to be able to turn the motion sensing on and off with LED indicating the current state.

    And also how do I program a timer in Homeworks to extend the on time for a motion event and also reset whenever motion is sensed again?

    Is there any documentation someone can point me towards relating to this?

    I was given a handout a few years ago at Homeworks class but I have never needed to use variables or custom programming.

    Thank you

  2. #2
    Senior Member
    Join Date
    Sep 2014
    Posts
    268
    For the button to turn on/off the motion sensing I would use variables and conditional programming. Have the button toggle a variable and then have the contact closure run to conditional programming something like "If Keypad Motion variable is ENABLED then Turn On Load X". Dont have the software open right now but something like that should be doable.

  3. #3
    Junior Member
    Join Date
    Sep 2018
    Posts
    9
    Thanks johnmax that worked. I will spell out exactly how I did it in case someone else can use it in the future.

    Go to program > variables, add variable with 2 states on and off

    On the keypad button program select program type "normal", button type "single action", LED logic "Scene", Under Press On tab select show all "variables" and the one you created should be there, have it changed state to on, under Hold have it changed state to off.
    On the keypad CCI tab, have the input program type "single variable" and choose your variable. under on tab have close turn the chosen lights on, and have open turn them back off. Under the off tab do nothing.

    As for extending the on time I did it on the motion sensor itself which was a LeGrand DT-300 watt stopper. Someone else picked that model of motion out I am not recommending it.

Similar Threads

  1. HomeKit Integration with HomeWorks - 2 Questions
    By starskycane in forum General Discussion - HWQS
    Replies: 2
    Last Post: 04-06-2022, 08:11 PM
  2. Homeworks QSX programming issues
    By rgellner in forum Programming - HWQS
    Replies: 1
    Last Post: 11-24-2020, 12:33 AM
  3. GRX-IRPS programming in HomeWorks QS
    By troltgen in forum Programming - HWQS
    Replies: 1
    Last Post: 02-21-2017, 10:38 AM
  4. Questions About Programming for VCRX Contact Closure Security/Smoke
    By schalliol in forum 3rd-party Integration - RA2
    Replies: 1
    Last Post: 11-17-2016, 12:59 PM
  5. Questions for QSE-CI-NWK-E programming?
    By Blair S. in forum Programming - Shades
    Replies: 0
    Last Post: 07-05-2013, 07:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •