I went to program an existing RadioRa2 system. After a few attempts I was able to locate the repeater and moved on to locating the bridge. An error was thrown and from then on I cannot locate the main repeater. I have tried a variety of networked and direct connection configurations. I've tried power cycling and even factory reset the main repeater.
NOTE: I am using Windows 11 ARM on Parallels Mac. Which has worked for the past 6 months or so on this same system.
Things I can verify:
- The repeater does grab an address from the router – verified on multiple subnets just to make sure.
- I can locate and connect to the Connect Bridge (though it fails shortly after, I believe, because the main repeater hasn't been found)
- I'm in the latest RadioRa2 12.10 application
- The main repeater firmware was updated less than a year ago (not sure which version since I can't connect to it).
- No errors lights are shown on the repeater – it starts up with a beep, flashes green once, then no lights.
I have sniffed the multicast traffic on the network and see packets from the Connect Bridge but see nothing from the repeater (despite it grabbing an ip address).
I'd appreciate any insight. Is the repeater bricked? And if so, is it possible to restore when it can't be located in Essentials?
Much Thanks!