Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Fan not showing up in Homekit

  1. #1
    Junior Member
    Join Date
    Nov 2021
    Posts
    2

    Fan not showing up in Homekit

    I now have 49 devices set up and all went well but for the last one. I installed a fan controller, it shows up and functions in the Lutron app but does not show in Homekit or other third party apps. Every thing else does. When I first installed it, it was blinking after I paired it to my Iphone. I uninstalled it, pulled out the tab and re linked it and it appears to work fine now. I also coupled a pico and it works. Could this be a wifi strength problem, there is a Caseta light control immediately next to it that was blinking but when I did the steps above then it works properly. Repeating, both the room light and fan show up in the Lutron app and function properly, the light is in the Homekit app but the fan is not.

    Thanks, Ed

  2. #2
    Lutron Technical Support
    Join Date
    Aug 2019
    Posts
    182
    It could possibly be a range issue where the fan control is on the cusp of range for the Caseta Bridge. How far away in feet is the fan control from the bridge?

Similar Threads

  1. CCO Pulsed Loads not showing in Connect App
    By anthonini in forum Troubleshooting - HWQS
    Replies: 2
    Last Post: 11-23-2021, 08:59 AM
  2. Pico not showing in Connect App
    By MitchE in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 04-25-2019, 12:27 PM
  3. New Lutron Connect App not showing On / Off status
    By MisterC in forum General Discussion - RA2
    Replies: 12
    Last Post: 06-28-2016, 05:00 PM
  4. Replies: 3
    Last Post: 10-28-2015, 05:02 PM
  5. RRd-6NA Not showing on Radio Ra 2 Software
    By andrebettor in forum Programming - RA2
    Replies: 2
    Last Post: 08-23-2014, 03:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •