Hi everyone,
I have a weird issue. I have RadioRA2 and have had the Connect Bridge for 3+ years on it without issue. I last programmed or made changes to the system about 10 months ago. The Connect Bridge works fine and I use the app on a daily basis.
Whenever I load my project in RA2 Essentials (or even export it from the main repeater), it shows the Connect Bridge as having an IP 172.31.3.5 or something like that, when its actual IP is 10.0.1.26. The Main Repeater shows the correct IP for it as 10.0.1.25 and if I click it, it shows the details and acts normal. For the Connect Bridge, if I click on it, it says it can’t find it and wants me to do the search for it and to press the button, acting like I never had one or something. If I press the button it finds it and adds it again.
The problem is any time I try to transfer the project, it pops up looking for the Connect Bridge again wanting me to push the button going on again like I've never had one. I do that, and then it says starting transfer, and then immediately “transfer cancelled.” No other explanation given, it just cancels every single time. If I remove the Connect Bridge from the project, everything works, I can transfer fine and it works normally.
I add the Connect Bridge back and try to transfer, and all devices fail saying “the device’s preset database was not updated.” If I delete the Connect Bridge from the project, it works fine!
If I run the Lutron app it downloads the configuration and works fine, even though the Connect Bridge isn’t part of the project anymore. Everything seems to work as normal, it just removed the wallpaper I had. I don’t really get it, it seems like the Connect Bridge is bad but it works right now, just not when part of the project.
Does it need to be added to the RA2 project? It's working right now without, so bit confused. Any ideas?