Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4

Thread: Occupancy Sensor

  1. #1
    Junior Member
    Join Date
    Nov 2013
    Posts
    5

    Occupancy Sensor

    I have a Homeworks Illumination system. I have installed a LOS-CDT-500R with a PP120H power pack. I have installed it per the application note using the grey wire connected to a keypad contact closure. I want the occupancy to turn off a set of lights if it does not sense any motion, otherwise lights stay on while occupied.
    I cannot get this to work. Any ideas or input is appreciated.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,326
    In the HWI software, go to the Control Station Programming screen. Select the appropriate keypad. Use the drop down box to change the Current View to Input Closures. Click on the closure that you connected the LOS to (1 or 2).

    You program this pretty much like any other keypad button. On the properties tab you can select Normally Open or Normally Closed. I don't remember what the default for the LOS is.

    All of the sensor settings - timeout, occ/vac, etc. are set manually on the LOS.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Nov 2013
    Posts
    5
    Quote Originally Posted by randyc View Post
    In the HWI software, go to the Control Station Programming screen. Select the appropriate keypad. Use the drop down box to change the Current View to Input Closures. Click on the closure that you connected the LOS to (1 or 2).

    You program this pretty much like any other keypad button. On the properties tab you can select Normally Open or Normally Closed. I don't remember what the default for the LOS is.

    All of the sensor settings - timeout, occ/vac, etc. are set manually on the LOS.


    I have done that.

  4. #4
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,326
    I would try shorting out the contact on the keypad. If the lights work then go back through the setup of the sensor.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. LED with dimming and occupancy sensor
    By bigtalljv in forum General Discussion - LED
    Replies: 0
    Last Post: 04-27-2021, 04:53 PM
  2. occupancy sensor
    By tom kupp in forum Design Assistance - HWQS
    Replies: 1
    Last Post: 07-11-2018, 09:22 PM
  3. Occupancy Sensor. Can this be done?
    By whirredup in forum Programming - RA2
    Replies: 5
    Last Post: 04-21-2017, 05:06 PM
  4. Querying Occupancy Sensor (LRF2-OC) and Remote Temp Sensor (LRF2-TWRB)
    By Fiasco in forum 3rd-party Integration - RA2
    Replies: 7
    Last Post: 11-12-2016, 07:17 AM
  5. Occupancy Sensor
    By texas doc in forum General Discussion - RA2
    Replies: 4
    Last Post: 05-18-2015, 09:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •