Occupancy Sensor

[sdaven]

I have a Homeworks Illumination system. I have installed a LOS-CDT-500R with a PP120H power pack. I have installed it per the application note using the grey wire connected to a keypad contact closure. I want the occupancy to turn off a set of lights if it does not sense any motion, otherwise lights stay on while occupied.
I cannot get this to work. Any ideas or input is appreciated.

[randyc]

In the HWI software, go to the Control Station Programming screen. Select the appropriate keypad. Use the drop down box to change the Current View to Input Closures. Click on the closure that you connected the LOS to (1 or 2).

You program this pretty much like any other keypad button. On the properties tab you can select Normally Open or Normally Closed. I don't remember what the default for the LOS is.

All of the sensor settings - timeout, occ/vac, etc. are set manually on the LOS.

[sdaven]

In the HWI software, go to the Control Station Programming screen. Select the appropriate keypad. Use the drop down box to change the Current View to Input Closures. Click on the closure that you connected the LOS to (1 or 2).

You program this pretty much like any other keypad button. On the properties tab you can select Normally Open or Normally Closed. I don't remember what the default for the LOS is.

All of the sensor settings - timeout, occ/vac, etc. are set manually on the LOS.

I have done that.

[randyc]

I would try shorting out the contact on the keypad. If the lights work then go back through the setup of the sensor.