Sending HTTP commands?

[q300wl]

Hi!

Add the Device: In Designer 21.5+, go to the 'Devices' tab and add an 'Ethernet Integration Device'.


Set IP & Port: Configure the device with the IP 192.168.5.219 and the typical port 80 for HTTP.


Command Format: Ensure your command format is correct. For the Yamaha Musiccast, it might look like: GET /YamahaExtendedControl/volume?volume=up HTTP/1.1.


Test the Command: Use the 'Test Command' feature in Designer to send the command and see if the Yamaha system responds.


Check Network: Ensure there's no firewall or network issue blocking the command.


If you're still facing issues, consider consulting the Designer's documentation or Yamaha's API documentation for specific command structures.

[acordova]

I'm doing exactly that. It is not a Yamaha device, but an equipment that can receive commands. The issue is that it has a username and password and the Ethernet Integration Device option to add a username and password is intended for a telnet connection.

Hi!

Add the Device: In Designer 21.5+, go to the 'Devices' tab and add an 'Ethernet Integration Device'.


Set IP & Port: Configure the device with the IP 192.168.5.219 and the typical port 80 for HTTP.


Command Format: Ensure your command format is correct. For the Yamaha Musiccast, it might look like: GET /YamahaExtendedControl/volume?volume=up HTTP/1.1.


Test the Command: Use the 'Test Command' feature in Designer to send the command and see if the Yamaha system responds.


Check Network: Ensure there's no firewall or network issue blocking the command.


If you're still facing issues, consider consulting the Designer's documentation or Yamaha's API documentation for specific command structures.