Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Wiring Issue

  1. #1
    Junior Member
    Join Date
    Dec 2021
    Posts
    1

    Wiring Issue

    I recently installed a PD-6ANS for the light switch on my patio.

    In the box where I was replacing the switch there were 3 sets of 14/2 coming out. I did not tag the lines and that is my fault, but when trying to connect I am assuming that all 3 black wires must be connected in some fashion to the 2 blacks on the switch.

    I tried several configurations to get the switch to have the green indicator light but only one configuration worked. I have 2 of the lines going to the bottom black and one to the top.

    This configuration allowed the switch to work however now I am having an issues with other switches on the same circuit (not 3-way). The other switches in the circuit will only work if the patio light is turned on.

    Any advice on how to wire with the 3 14/2 wires?

  2. #2
    Lutron Technical Support
    Join Date
    Aug 2019
    Posts
    182
    Hello. Do you have a neutral connection available in this location. (bundle of whites capped off in back of the box). https://www.casetawireless.com/Docum...ced%20Inst.pdf Pages 33-35

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Tie all the whites together. You will need a pig-tail to connect to the switch.

    Turn the power on. Using a voltage tester (ex: https://www.homedepot.com/p/Klein-To...VT5A/312332733) determine which black is hot. One of the 2 remaining wires goes up to the light, the other goes to the next box in line. Connect the wire going to the light to one black on the dimmer. Connect the remaining two to the other black.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Wiring issue
    By Medieval1Knight in forum Troubleshooting - Controls
    Replies: 3
    Last Post: 10-27-2020, 12:35 PM
  2. Wiring issue
    By Alishio in forum Troubleshooting - CAS
    Replies: 2
    Last Post: 10-01-2020, 06:44 PM
  3. Wiring Issue
    By Blake123 in forum Troubleshooting - CAS
    Replies: 3
    Last Post: 09-26-2020, 06:11 PM
  4. Issue with wiring of Lutron Diva dimmer. Original switch has 5 wires.
    By kdr2824 in forum General Discussion - Controls
    Replies: 3
    Last Post: 09-21-2020, 04:37 PM
  5. Mixed load on PD-6ANS or PD-6WCL problem. Wiring issue?
    By istredd in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 02-16-2018, 08:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •