Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: 0-10V adapter to phase dimming - RRD-6ND switch

  1. #1
    Junior Member
    Join Date
    Jun 2021
    Posts
    2

    0-10V adapter to phase dimming - RRD-6ND switch

    We received a led linear suspension fixture with the following specs:


    120-277VAC Input
    Hot, Neutral, Ground, Dim+, Dim-

    Non-Dimmable: Switch on or off
    0-10V: Dim to 1%


    The light fixture is line voltage, but the driver is not phase dimmable. I have a Ra2Select RRD-6ND dimmer switch for this light - what is the easiest way to make this work?

    I came across this gimmicky adapter:
    Responsiv Blink'n'Dim Adapter, Universal Dimmer for 0-10V Dimmable LED Fixtures, Retrofit Kits or Fluorescent Ballasts. Dim with Existing Switch. No New Wiring in Walls. Better Than Wireless.: Amazon.com: Tools & Home Improvement

    I know Lutron has PowerPaks, but unsure which would work with the 5 wires > this would then need to be controlled by a Pico remote instead of the RRD-6ND dimmer?

    The manufacture isn't making any concessions and doesn't have drivers or power supplies to make this work. Any advice would be greatly appreciated. Thank you.

  2. #2
    Does the control need to integrate into a Ra2 System? If so, you could use the LMJ-5T-DV-B PowPak that works with Radio Ra2. It is 0-10V rated. It will mount up in the plenum space near the fixture. It is the master dimmer/device and then you would pair an RF Pico remote to it, and then if you wanted mount the RF Pico remote at the closed off wallbox. Here is the spec submittal for the LMJ-5T-DV-B @ https://www.lutron.com/TechnicalDocu..._0-10_Spec.pdf. If you have any other questions our tech support can be reached at (1-888-588-7661) and support@lutron.com.

Similar Threads

  1. Circuits on LQSE Phase Adaptive Dimming Module Zone blink on and off.
    By arman.ansari in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 07-13-2021, 03:43 PM
  2. Reverse Phase VS Forward Phase Dimmers on HWQS
    By savimagc in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 03-29-2021, 12:53 PM
  3. What happened to 3-wire phase dimming?
    By supermarket in forum General Discussion - LED
    Replies: 2
    Last Post: 09-07-2019, 12:39 AM
  4. Load Adapter for LED Tape Light Dimming?
    By tabraham in forum Troubleshooting - CAS
    Replies: 8
    Last Post: 04-20-2018, 08:16 PM
  5. Phase control dimming PowPak
    By pscheetz in forum Design Assistance - Vive
    Replies: 2
    Last Post: 04-18-2016, 09:31 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •