I added a 3 button hybrid keypad, HN3BSRL, along with an RD-RD in a location that previously had non-RA2 3-way switches.
My question is regarding what programming if any is needed for the hybrid keypad to have the first button control the load of the light that was previously managed by the 3-way switches, which in my case is the recessed cans at our Friends door.
In the essentials software, I have tried programming it 2 different ways:
- Assigning a 100% load to the first keypad button- which does turn the light on and allow me to dim it with the raise/lower buttons, but does not turn the light off with a single press or double press
- Not assigning any programming to that button, which doesn't do anything when it is pressed.
In all cases, the RD-RD works as expected and controls the light fine.
See attached screen shot where I have assigned a 100% load to the first button to control the "Friends Cans".
Thanks for your help.
Glenn