Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Pico connects but not dimmer switch

  1. #1
    Junior Member
    Join Date
    Nov 2021
    Posts
    1

    Question Pico connects but not dimmer switch

    Just installed a dimmer and pico remote and bridge that came with the starter kit. The bridge is connected to my Netgear Nighthawk router. I started pairing the first dimmer and got to the point where the LEDs blink rapidly and then the app stalled there. After about 5 minutes I backed out and retried several times but got stuck at the same point. I tried following the advanced instructions for deleting the pairing but could not get past step 3 (light flashes 3 times then turns off). I then tried to pair the pico remote and it paired fine. Tried again to pair the switch but no luck. Tried deleting the app and reinstalling but no luck. Any suggestions for how I get this dimmer switch connected?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Try resetting the device back to factory defaults. The link below is our very own SDR-Mike demonstrating the process. You will notice he taps 5 or 6 times. This is just to ensure he gets 3 taps within the time allotted. The device will stop counting after 3.

    https://www.dropbox.com/s/msuopf2ppe....MOV?dl=0Video
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Thoughts on using Pico instead of dimmer/switch
    By uscpsycho in forum Design Assistance - RA2
    Replies: 4
    Last Post: 12-18-2023, 10:48 PM
  2. Repeater Connects but I cant add devices near it. Help!!
    By joelbess in forum Troubleshooting - CAS
    Replies: 2
    Last Post: 08-15-2021, 08:01 PM
  3. 2 button light switch with Dimmer Pico?
    By schudhri in forum General Discussion - CAS
    Replies: 1
    Last Post: 06-30-2020, 11:31 AM
  4. Dimmer Pico paired to 2 Button Switch
    By TexasGreg in forum General Discussion - CAS
    Replies: 1
    Last Post: 10-05-2019, 08:36 PM
  5. Pico Dimmer Switch and Smart Switch in a multi-location setup
    By jbaude in forum General Discussion - CAS
    Replies: 1
    Last Post: 11-08-2017, 04:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •