Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Convert 3 load switch into seetouch keypad

  1. #1
    Junior Member
    Join Date
    Nov 2021
    Posts
    1

    Convert 3 load switch into seetouch keypad

    I have a 3 load switch in a bathroom. Is there anyway this can be converted to a seetouch keypad using a ra2 system? Please see picture.

    Thanks!
    Attached Thumbnails Attached Thumbnails 3loadswitch.png  

  2. #2
    Junior Member
    Join Date
    Mar 2021
    Posts
    15
    Assuming this controls a bath fan with light and heat so if 1 of the loads is a dimmable light you could use a hybrid keypad for the light load. You will still need 2 load controllers for the other 2 loads. If one of the loads is a heater you’ll probably need an LMJ-16R-DV-B because it might overload an RRD-8ANS
    The exhaust fan will most likely work fine on an RRD-8ANS but you’ll have to find a closet or somewhere to hide it, or an LMJ-16R-DV-B

Similar Threads

  1. seeTouch Keypad programming - Dimmer Level = Last Level
    By GoFast in forum Programming - RA2
    Replies: 1
    Last Post: 08-30-2021, 09:55 AM
  2. RRD-2ANF Controlled by Seetouch keypad
    By Beick in forum Programming - RA2
    Replies: 2
    Last Post: 12-21-2017, 05:25 PM
  3. Convert In-Wall dimmer to Switch
    By essbase in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 07-14-2016, 02:53 PM
  4. Safest (best?) way to add new wired seeTouch keypad?
    By jkvossen in forum General Discussion - HWQS
    Replies: 4
    Last Post: 12-04-2014, 08:11 AM
  5. Single seeTouch Keypad for Lights and Shades
    By dinom in forum General Discussion - RA2
    Replies: 1
    Last Post: 09-05-2014, 09:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •