Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Programming Time Out on MSCL-OP153M

  1. #1

    Programming Time Out on MSCL-OP153M

    Just installed a new MSCL-OP153M and all is well. However, in trying to change the default 5 minute time out we are stumped.
    Have gone thru the directions many times and keep striking out.
    THis is the procedure we are following:
    1.Pull out FASS
    2. Press and Hold T for 5 seconds
    3. Continue holding T and push FASS back in
    4. Release T when IL(very top) starts blinking
    5 Use up/down to scroll to the Time Out LED (Which is the bottom one)
    6. What should be done here?

    7. USe up/down to set time out. We want 30 minutes but can not toggle to that position, It goes only to the 15 minute duration.

    Somewhere after step 5 we are missing something before setting to 30 minutes. THe supplied directions have been gone over for a couple of hours!

    Anyone have an idea?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Swap steps 2 and 3. The FASS removes power from the electronics. Holding the button while the FASS is out will not have any effect.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. MSCL-OP153M with MA-AS companions?
    By leggwork in forum General Discussion - Controls
    Replies: 3
    Last Post: 04-08-2021, 06:11 PM
  2. MSCL-OP153M Always On?
    By lijinv in forum General Discussion - Controls
    Replies: 1
    Last Post: 09-10-2018, 08:54 PM
  3. MSCL-OP153M Auto-oin
    By kbogott in forum Programming - Controls
    Replies: 1
    Last Post: 02-23-2017, 04:17 PM
  4. Using 2 MSCL-OP153M on the same 3-way circuit.
    By Brian W. in forum General Discussion - Controls
    Replies: 0
    Last Post: 02-06-2014, 03:25 PM
  5. MSCL-OP153M and Auto-Off
    By Brian W. in forum General Discussion - Controls
    Replies: 0
    Last Post: 02-06-2014, 03:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •