Although when I went back and told Inclusive to Transfer again, it seems to have hung up at 77%.
Code:
5:37:46 PM: Starting Transfer...5:37:50 PM: Setting the system date and time (11/12/2015 5:37:50 PM).
5:37:53 PM: Cleaning memory on the main repeater...
5:38:13 PM: Sending Files to System(s)
5:38:45 PM: Transferring databases to devices...
5:39:07 PM: Finalizing transfer. Please wait a few minutes...
It's now 6:14 and it's stuck. Cancel worked, saved to a new project. Quitting and restarting Inclusive now...
Curiously it brought up the 'Find Main Repeater' dialog. Which reported:
Code:
Please select the serial number of the repeater in the corresponding room. Found 2 main repeaters on the network.
Pinging IP address 192.168.12.7 to make sure the main repeater is reachable... Attempt #1
Pinging IP address 192.168.12.8 to make sure the main repeater is reachable... Attempt #1
Sending IP multicast to repeater with serial number 0086F204 to verify network connectivity...
IP multicast failed for repeater with serial number 0086F204. Please check the network connections to this repeater and firewall settings and try again.
Found 2 main repeaters on the network.
Pinging IP address 192.168.12.7 to make sure the main repeater is reachable... Attempt #1
Pinging IP address 192.168.12.8 to make sure the main repeater is reachable... Attempt #1
Sending IP multicast to repeater with serial number 0086F204 to verify network connectivity...
Odd, both of these repeaters are literally plugged into the same switch as this laptop running Inclusive. All hard-wired Ethernet, all on static addresses.
I do happen to have Sonos gear on this network, but off on a different switch (actually two hops away). But none of it has been active at all, not for several days. I power-cycled the switch and that allowed Inclusive to see them again. oooo-kay, nothing like network voodoo to complicate the mix. Once that was restarted Inclusive resumed:
Code:
6:16:23 PM: Starting Transfer...
6:22:48 PM: Setting the system date and time (11/12/2015 6:22:48 PM).
6:22:51 PM: Cleaning memory on the main repeater...
6:23:12 PM: Sending Files to System(s)
6:23:45 PM: Transferring databases to devices...
6:24:07 PM: Finalizing transfer. Please wait a few minutes...
6:26:40 PM: Transfer completed. 94 out of 94 activated devices were updated successfully.
On completion I told it to transfer again and got a new error dialog
Code:
Syncing was incomplete. Please check your network connection and try again. Caution: Continuing further will overwrite your homeowner programming tweaks.
Mmmm, what now? Fine, clicked Continue. Progress bar marches through the stages and the transfer continued.
Code:
6:27:50 PM: Starting Transfer...6:30:52 PM: Setting the system date and time (11/12/2015 6:30:52 PM).
6:30:55 PM: Cleaning memory on the main repeater...
6:31:16 PM: Sending Files to System(s)
6:31:48 PM: Transferring databases to devices...
6:32:09 PM: Finalizing transfer. Please wait a few minutes...
6:34:37 PM: Transfer completed. 94 out of 94 activated devices were updated successfully.
Don't get me wrong, I'm glad to have as robust a tool as this to handle the design and programming. But 9.2 does not seem to be without issues...
But hey, at least my haunted wall box has been exorcised.