Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Dimmer for Allen+Roth Daphne LED flush mount ceiling fixture

  1. #1
    Junior Member
    Join Date
    Sep 2021

    Dimmer for Allen+Roth Daphne LED flush mount ceiling fixture

    I just replaced a kitchen light with the Allen+Roth LED light fixture. Allen+Roth recommends Lutron MACL-153MLH-WH dimmer, but this dimmer only works on the lower light settings; lights flicker at any light output level above about 35%.

    Any suggestions on which Lutron dimmer would work best on this light fixture?

    Thank you.

  2. #2
    Hello! We are sorry to hear of the issue occurring with your new LED light fixture and your MACL-153M dimmer. We'd recommend to contact the manufacturer and have them clarify the testing that was done, and if any of the recommended dimmers performed better than others. Lutron does not test third party fixtures. With the issue occurring we'd recommend to adjust the high end trim and see if that assists. These steps can be found under the advanced programming guide @ Also, if you have a neutral connection (bundle of white wires) in the wallbox you could consider a neutral based version of the dimmer, the MA-PRO. Potentially LED fixture is calling for ELV dimming and the MA-PRO is rated for this. We hope this helps! If you have any other questions our tech support is availabe 24/7 at (1-888-588-7661) or

Similar Threads

  1. QS HVAC controller with Flush Mount sensor- HVAC forum?
    By digit1 in forum General Discussion - HWQS
    Replies: 5
    Last Post: 01-23-2017, 05:30 AM
  2. HWQS HVAC controller & Wired Flush Mount Sensor
    By jihad kutkut in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 01-02-2017, 10:32 AM
  3. HVAC Control & wired flush mount sensor
    By zgray1 in forum Design Assistance - HWQS
    Replies: 3
    Last Post: 10-11-2015, 12:41 PM
  4. New flush mount cut in ring for the occ/vac sensor , finally
    By Scottydont in forum General Discussion - RA2
    Replies: 2
    Last Post: 06-20-2014, 03:56 AM
  5. TouchPRO wired sensor, flush mount
    By Ty W. in forum General Discussion - RA2
    Replies: 4
    Last Post: 06-19-2013, 02:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts