Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Compatibility

  1. #1
    Junior Member
    Join Date
    Aug 2014
    Posts
    22

    Compatibility

    After reviewing Application Note #559 I am still wondering if I could effectively use a single HALOGEN 35W MR16 bulb with a RRD-6NA and a simple ELV 12V transformer like this: https://ltftechnology.com/ltf-ta-te-...formers/Thanks, Richard
    ~~~Richard___ Santa Cruz, CA

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    The only way to know for sure is to test it. I believe the chances are pretty good of it working. You will probably have to bump up the low end but it should work.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Aug 2014
    Posts
    22
    Thanks Randy. I just ordered a RRD-6NA from Lutron's Obsolete Products Dept for $160!
    ~~~Richard___ Santa Cruz, CA

  4. #4
    I can't confirm it as your link is down, but it does work, I was initially using that setup.

Similar Threads

  1. RRD-6D (LED compatibility)
    By falcon in forum General Discussion - RA2
    Replies: 2
    Last Post: 08-23-2020, 11:04 AM
  2. Compatibility
    By Sharonl in forum General Discussion - Controls
    Replies: 1
    Last Post: 07-01-2018, 09:52 PM
  3. Compatibility help!!!
    By Michaelokc in forum Design Assistance - CAS
    Replies: 2
    Last Post: 02-26-2018, 11:11 AM
  4. E11 compatibility
    By bravo in forum Compatibility - LED
    Replies: 4
    Last Post: 05-02-2017, 03:14 PM
  5. LED - Wac Lighting Compatibility
    By Jerani in forum Design Assistance - HWQS
    Replies: 5
    Last Post: 04-09-2015, 09:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •