I have a SeeTouch keypad situated by the main entrance and the requirements are:
On Button:
* Press - (Action) turn on the lobby lights
* Hold (1.5s) - set lighting & climate into home mode
* Double tap - put system into demo mode (basically turn on all the lights throughout)
Off Button:
* Press - (Action) turn off the lobby lights
* Hold (1.5s) - set lighting & climate into away mode
* Double tap - turn off demo mode
Both the On & Off buttons are set up as Conditional
The Off Button Hold event is:
1. Run shared scene - away (all lights off apart from the lobby)
2. Run shared scene - close all shades
3. Delay 5s
4. Run - (Action) Lobby off
My issue is specifically with the Off Button Hold event.
When this button is held the press event is still being triggered so the lobby lights are are turning off straight away (the press event is being triggered)
As you can see from the Off Hold event, this must be delayed by 5s
If I remove the programming from the Off Press event, then the hold event runs as I intend.
The press & hold logic is not as expected.
What's the work around?
Cheers
-s