Thanks Thanks:  0
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: control HomeWorksQS system via KNX

  1. #1
    Junior Member
    Join Date
    Oct 2013
    Posts
    1

    control HomeWorksQS system via KNX

    Is there any interface/gateway that I could use to control HomeWorksQS system via KNX?

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    62
    You can control a HomeWorks QS system from a 3rd-party device over either an RS-232 connection (using a supported converted) or an Ethernet connection (over Telnet). For directions on setting up a 3rd-party system to control the HomeWorks QS system, please reference Scenarios 1 and 3 in this app note.

    If you have difficulty setting up the 3rd-party system, feel free to reference the existing thread on troubleshooting 3rd-party integration in HWQS here.

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    One very important note that should be noted. When using the B&B model DO NOT set or use a password. It will not work. I have used them before and after I figured out that the password was screwing me up it worked perfectly. It seems you have to leave this device unsecured on the network unless I haven't spent enough time playing with it.

  4. Likes Armando B. liked this post

Similar Threads

  1. Partitioning in HomeWorksQS
    By Craig W. in forum Programming - HWQS
    Replies: 13
    Last Post: 09-19-2017, 09:59 AM
  2. Suggestions on how to integrate a split-system ductless HVAC system with RadioRA2
    By RA2-Designer-Gal in forum Design Assistance - RA2
    Replies: 4
    Last Post: 05-10-2017, 11:43 AM
  3. Control HomeWorks system via Netstreams DigiLinx, need help please!
    By uasya in forum 3rd-party Integration - Legacy HW
    Replies: 6
    Last Post: 10-17-2013, 06:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •