Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Run missed timeclocks on start-up/re-start

  1. #1
    Junior Member
    Join Date
    May 2021
    Posts
    12

    Run missed timeclocks on start-up/re-start

    Is it possible to run a missed timeclock after the program has started? The project specification stipulates that certain lighting scenes are selected depending on time of day. In my current project I have four timeclock events setting a variable:1. Sun-Sat 5am - set var 'period' = morning (default) 2. Sun-Sat 9am - set var 'period' = day 3. Sun-Sat 5pm - set var 'period' = evening 4. Sun-Sat 00am - set var 'period' = night. The 'period' var is then used with conditional logic to select the correct scenes depending on time. When the program starts it will always default to morning. If I upload a change to the project at say 10am, then the 'period' var is incorrect until the next timeclock event occurs at 5pm. How can I force the project to trigger missed events? Cheers -s

  2. #2
    Senior Member
    Join Date
    Sep 2014
    Posts
    140
    This is why I have moved all of my schedule logic over to the Crestron side of my programs. The Lutron logic seemed too finicky and I needed this exact behavior. Wpuld be good if it checked the current time on startup and then set all time based variables and schedules

  3. #3
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    238
    Thank you for your post slip.cougan.

    We would need an action for the missed time events to run most likely. We can take a closer look with your project file and starting a case with hwsupport@lutron.com. There we can work with you directly to see if we can come up with a programing fix for you! Hope this helps!

  4. #4
    Junior Member
    Join Date
    May 2021
    Posts
    12
    Thanks John,This has now been processed through Lutron support (which was fantastic)However as you stated, simply not possible with the existing Lutron software.I have asked for this to be referred to engineering.Regards-s

Similar Threads

  1. RadioRa2 12.7 will not start
    By ayerforce in forum Programming - RA2
    Replies: 3
    Last Post: 09-06-2020, 09:03 PM
  2. Cold start 1 flash then nothing.
    By r.jordan90 in forum Performance Issues - LED
    Replies: 3
    Last Post: 09-23-2019, 02:47 PM
  3. Start / End Date for Timeclock
    By dwclarknu in forum Design Assistance - RA2
    Replies: 3
    Last Post: 07-01-2015, 07:04 PM
  4. Unable to Start Activation
    By Armando B. in forum Troubleshooting - RA2
    Replies: 0
    Last Post: 02-10-2014, 05:05 PM
  5. Start/Restart Sequence When Conditions are Met
    By TurnipTruck in forum Programming - HWQS
    Replies: 5
    Last Post: 01-10-2014, 11:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •