Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: TU-Wire Driver and Incandescent Load on Same Maestro Dimmer?

  1. #1

    TU-Wire Driver and Incandescent Load on Same Maestro Dimmer?

    Does anyone know if one Maestro dimmer be connected to both an incandescent load as well as a TU-Wire driver or ballast?

  2. #2
    Lutron Technical Support
    Join Date
    Jan 2021
    You would be able to use a Maestro dimmer in an application like this. You will most likely have to raise the low end of the dimmer to the required level for the low end of the TU-Wire ballast, but other than that it should work. A neutral based TRIAC dimmer would also help avoid issues at high end on the dimmer side of things. We would suggest using the MA-PRO.

Similar Threads

  1. 3 Way Dimmer - 1000 W - LED and Incandescent
    By CardsFan1 in forum General Discussion - Controls
    Replies: 1
    Last Post: 11-08-2018, 03:33 PM
  2. Low end trim and LED Tape issues with LTE 2 wire Hi-lume driver
    By dvpvic in forum Lutron Hi-Performance LED Driver - LED
    Replies: 1
    Last Post: 05-01-2018, 06:52 PM
  3. RA2 Maestro Dimmer for Lutron Tu-Wire ballast
    By Dimerize in forum General Discussion - RA2
    Replies: 2
    Last Post: 02-05-2016, 07:38 AM
  4. Combination of incandescent/ LED on ELV dimmer
    By bma sparky in forum General Discussion - LED
    Replies: 3
    Last Post: 05-22-2015, 12:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts