I've recently completed a HWQS project where we're using a number of Pulsed contact closure loads to perform basic functions, i.e open, close, stop commands on Velux windows, Velux Blinds, Garage doors etc. These are mainly programmed onto button presses. I've used maintained outputs quite frequently on other projects and these show up in connect. However, I've noticed that the Connect App doesn't show Pulsed contacts which is a bit gutting. Can anyone fathom why the maintained cco's are exposed to the app, but the pulsed aren't?? Is there a clever workaround (or better, a simple workaround) that I'm unware of? Thanks