Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Repeater Timer Apparently Lost Time

  1. #1
    Junior Member
    Join Date
    Mar 2021

    Repeater Timer Apparently Lost Time

    After a remodel and expansion I'm in the midst of adding additional controls and adjusting those that were already there when I see that the timer has apparently lost its time. Lights that should come on at sunset are coming on far earlier than that and appear to be going off early too. We did just have a Daylight Savings time change but it has never been a problem before so how can it be re-set?

  2. #2
    Hello! Thank you for your inquiry. The time can be reset by performing a transfer of the project file. This will set the Main Repeater's time to the PC's time used to do the transfer. There are also additional time settings in the Project Settings in the software to change the adjustments for DST.

Similar Threads

  1. Set a timer to turn off lights after X amount of time?
    By yellowhammer in forum Programming - CAS
    Replies: 5
    Last Post: 03-11-2020, 11:00 AM
  2. Lost project and main repeater issues
    By jspot55 in forum Troubleshooting - RA2
    Replies: 10
    Last Post: 05-17-2018, 12:17 PM
  3. XML info from Main Repeater: date and time
    By Dimerize in forum Programming - RA2
    Replies: 4
    Last Post: 01-30-2016, 03:26 AM
  4. 6NA dimmer apparently fried by a bad power outage
    By DenebaTech in forum Troubleshooting - RA2
    Replies: 8
    Last Post: 10-13-2015, 01:44 PM
  5. Where does the main repeater get the clock/date and time from?
    By jchitrady in forum General Discussion - RA2
    Replies: 6
    Last Post: 09-01-2014, 07:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts