Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: RRD-Pro pulsing randomly

  1. #1
    Junior Member
    Join Date
    Feb 2021
    Posts
    2

    RRD-Pro pulsing randomly

    Hi all, I have a weird situation. I did a install in a small office, 1-main repeater with 20-rrd-pro dimmers. The dimming/switching works fine in forward or reverse phase selection. But randomly every 8 hrs or so different rrd-pro's cycle off then back on again. The load is led tape with a 24v driver, I have used the same set up on a different project and it works fine. could something be interfering on the radio frequency causing this? could it be the main repeater?Thanks in advance!

  2. #2
    Is this in a 3 way system? If so make sure the dimmer ihas the SL going to the light. Is it a short piece of tape and maybe you have not hit the min wattage?

  3. #3
    Junior Member
    Join Date
    Feb 2021
    Posts
    2
    Quote Originally Posted by Bill13 View Post
    Is this in a 3 way system? If so make sure the dimmer ihas the SL going to the light. Is it a short piece of tape and maybe you have not hit the min wattage?
    Thanks for the reply Bill. It is not in a three way system and the lights are about 60W of tape each so I don't think that is the issue. The problem doesn't occur at night when the office is empty, so I think it is an issue when people are there interfering with the frequency....but I'm pretty new at this so don't know for sure. The lights worked fine when I had regular switches installed and they also worked fine when I first installed the system( I installed it at night time). Is there a way to change the frequency that the system works on, or cancel out the noise from systems in use during the day?

  4. #4
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    217
    Thank you for your post BrianP

    You could change the frequency of the system. Please follow this app note https://www.lutron.com/TechnicalDocu...ary/048688.pdf . Note this will require all the devices be reactivated as we are changing the frequency of the system. Hope this helps!

Similar Threads

  1. MS-OPS2-WH Turning On Randomly
    By Arnie in forum General Discussion - Controls
    Replies: 5
    Last Post: 01-09-2021, 11:20 AM
  2. Maestro dimmer flickering/pulsing at low end. Weird problems.
    By Danwec in forum Performance Issues - LED
    Replies: 4
    Last Post: 11-07-2020, 06:13 AM
  3. Lights turning on randomly
    By cptndave in forum Troubleshooting - CAS
    Replies: 2
    Last Post: 09-05-2019, 12:30 PM
  4. Pulsing voltage from load line on 3-way w/ Caseta wireless dimmer
    By Karsten in forum Troubleshooting - CAS
    Replies: 7
    Last Post: 06-04-2019, 08:35 PM
  5. Caseta randomly turns on and off
    By reedm in forum Troubleshooting - CAS
    Replies: 4
    Last Post: 02-08-2016, 05:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •