Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: Help-4 way Maestro MSOP-S5M WITH 2 companion switches installed not fuctioning

  1. #1
    Junior Member
    Join Date
    Jan 2021
    Posts
    1

    Help-4 way Maestro MSOP-S5M WITH 2 companion switches installed not fuctioning

    Need a little direction looked at the set up for this configuration 4way mechanical switch replaced by the MSOP-5SM (occupancy switch) and 2 companion switches but instead of showing the 4 way it shows a companion switch going in its place . I thought I saw the instructional for my situation but appears not and I am left with no lights but a clicking sound on the MSOP-5SM when I hit the companion switches. Would anyone jump in and advise me where the help for this would be. Much appreciated and thank you Laurence My config is; switch one 3 way( line power in ) - switch two 4 way and switch three , 3 way.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,076
    Dear Lutron,

    He's right. If you follow the link in the installation instructions it takes you to the general web page for Maestro sensors. No useful information or links to wiring diagrams, etc. I did find a wiring diagram but it only shows a single companion.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    281
    Good Morning Gentlemen,The MS-OPS5M can be installed in the 4 way location, along with a MA-AS in each 3 way location. The key to the wiring is that all the blue terminals need to be connected. We normally suggest using the odd colors wire in your travelers (commonly red) In this case the sensor in the 4 way will have 2 red wires connected to the blue screw. All the other black wires would get connected to the black and brass screws. Use black for your input connections and the brass screws to run to the next control and then to the load. If you have additional questions you can call our 24/7 Technical Support Team at 1-844-588-7661.

Similar Threads

  1. Lutron Maestro (with two companion dimmer switches)
    By Postorino in forum General Discussion - Controls
    Replies: 1
    Last Post: 12-28-2020, 04:35 PM
  2. Difference between Maestro MA-R and MA-RR Companion Dimmer Switches
    By Puhrmann in forum General Discussion - Controls
    Replies: 1
    Last Post: 05-06-2020, 08:45 PM
  3. Maestro Companion dimmer
    By ywittner in forum General Discussion - Controls
    Replies: 1
    Last Post: 03-27-2019, 11:06 PM
  4. Converting Maestro & Maestro companion dimmers to Caseta
    By doug50 in forum Design Assistance - Controls
    Replies: 2
    Last Post: 12-12-2018, 10:16 AM
  5. Maestro companion dimmers and switches with QS
    By LGSONE in forum General Discussion - HWQS
    Replies: 1
    Last Post: 05-01-2015, 09:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •