Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Conditional Visor Control

  1. #1
    Junior Member
    Join Date
    Feb 2021
    Posts
    2

    Conditional Visor Control

    Can one assign a timeclock and mode to a scene triggered from a Visor Control input? For example, I have a scene of RF relay modules being activated to run from a contact closure on the VCX, but would like this to only occur while in the Away mode and then timed to deactivate after one hour. Possible? Thanks in advance.

  2. #2
    I think that is a bit too complex.

  3. #3
    Junior Member
    Join Date
    Feb 2021
    Posts
    2
    How about just assigning it to a mode?

  4. #4
    Hello! You can try using a combination of Timeclock, Timeclock Modes, and Rollback (under Occupancy in the programming tab) to make this work. You set timeclocks directly to the Outputs of the VCRX, have the timeclock run in a specific mode, use the VCRX Keypad buttons as Timeclock Mode changes, and set the room the VCRX is in to a 1 hour rollback. If you need more support with this, you can send an inquiry to systemsupport@lutron.com.

Similar Threads

  1. Visor Control Receiver & Garage OH Door
    By radioRA2automation in forum Troubleshooting - RA2
    Replies: 2
    Last Post: 02-24-2021, 02:16 PM
  2. visor control transmitter compatibility
    By SparkyCoog in forum 3rd-party Integration - RA2
    Replies: 2
    Last Post: 01-27-2021, 10:21 PM
  3. Garage Doors with Visor Control
    By xfiring in forum General Discussion - RA2
    Replies: 1
    Last Post: 08-06-2018, 04:58 PM
  4. Security concern regarding visor control transmitter
    By dvpvic in forum General Discussion - RA2
    Replies: 1
    Last Post: 01-18-2018, 09:01 PM
  5. How to program Homelink and Visor Control
    By uhrgenau in forum Programming - RA2
    Replies: 8
    Last Post: 10-29-2013, 09:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •