Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4

Thread: LOS-CIR-450 Sensor to drive CCI on keypad

  1. #1
    Junior Member
    Join Date
    Oct 2015
    Posts
    3

    LOS-CIR-450 Sensor to drive CCI on keypad

    I need to know if it is possible to use a LOS-CIR-450 sensor to drive the CCI on the back of a homeworks keypad to activate a vacancy action. What i'm trying to do is make this sensor operate like a vacancy sensor, press the keypad to turn loads on and the sensor to turn loads off if it does not sense motion

  2. #2
    Senior Member
    Join Date
    Sep 2013
    Posts
    424
    looks like you'll need a 24vdc power supply and a LV relay to match. This sensor output will be 24vdc, not a dry contact.

  3. #3
    Junior Member
    Join Date
    Oct 2015
    Posts
    3
    i was planning on using the 24 volt from the homeworks keypad loop and trying to use the sensor output to signal the contact on the back of the keypad to activate an action that would shut off the loads in the bathroom.

  4. #4
    Senior Member
    Join Date
    Sep 2013
    Posts
    424
    fair enough. but i think you'll still need a 24 volt dc relay to change the sensor's output to a dry contact for the CCI input on the keypad.

Similar Threads

  1. Daylight sensor
    By texas doc in forum General Discussion - RA2
    Replies: 15
    Last Post: 09-19-2019, 01:50 PM
  2. Occupancy Sensor
    By texas doc in forum General Discussion - RA2
    Replies: 4
    Last Post: 05-18-2015, 09:16 PM
  3. Humidity Sensor?
    By Terra X2 in forum General Discussion - HWQS
    Replies: 2
    Last Post: 07-24-2014, 01:01 PM
  4. Setsquare PIR sensor
    By jimathome in forum Programming - Legacy HW
    Replies: 4
    Last Post: 01-10-2014, 12:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •