I've set up Inclusive on a new machine that uses Windows 10 Pro x64. I've loaded up a project to edit a timeclock event.
It seems to take an unusually long time to do a transfer to a two repeater system. It was hung up a 48% for more than 5 minutes at the DualActionProgrammingMode stage. It only just now popped loose from that and is still grinding slowly forward.
Two past failures took 13 and 15 minutes, respectively, before they gave up with a Transfer Unsuccessful.
I quit/restarted the Ra2 program, and cold booted the machine, with no success. One that was running while I was typing this died as well, also at the 13 minute mark. But this one, at least, did succeed in making at least one of the main repeaters "beep" like it normally does during a transfer. The previous tries did not.
Has anyone else run into this and found the cause/solution?
I'm going to power-cycle the repeaters next.