Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: unusual wiring to install MS-OPS2

  1. #1
    Junior Member
    Join Date
    Jan 2021
    Posts
    1

    unusual wiring to install MS-OPS2

    Hello,I want to install motion sensor switch for my basement ceiling light. I guess it's single pole.https://drive.google.com/file/d/1M3o...usp=sharingand I found that it have 2 wire (black, white) and 1 ground.I've looked at the instruction and tried all the combination of wiring but no luck.Please help, Thank you

  2. #2
    did you figure this out....i have the ms-ops2-wh with 2 black wires, a bare ground, and a white wire with green cover trying to connect to single pole with one black and one whitewhat to do with two (2 ) black wires on new switch

Similar Threads

  1. Ms-ops2
    By igenr8 in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 09-18-2020, 02:13 PM
  2. Need help wiring MS-OPS2 dimmer
    By Don Van O in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 05-01-2020, 04:19 PM
  3. Replies: 2
    Last Post: 02-27-2019, 12:36 PM
  4. MS-OPS2 sticking o
    By Neil Gillies in forum Troubleshooting - Controls
    Replies: 6
    Last Post: 05-07-2018, 08:50 PM
  5. three MS-OPS2 in parallel
    By pauloeuvray@hotmail.com in forum Design Assistance - Controls
    Replies: 1
    Last Post: 02-27-2017, 12:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •