Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: PD-5ANS & PD-6ANS Delayed Lights ON

  1. #1
    Junior Member
    Join Date
    Jan 2021
    Posts
    1

    Question PD-5ANS & PD-6ANS Delayed Lights ON

    Just installed a 3-way PD-5ANS switch with PICO remote at second location to operate recessed LED ceiling lighting (4 bulbs) in the dining room. After installation and confirming the wiring, everything worked once the circuit breaker power was turned back on. Lights/green LED came on when I pressed the ON switch. Turned off when I pressed the OFF switch. The problem comes after the first ON-OFF cycle. When I press ON again, the lights do not turn on immediately and take anywhere from 5 to 20 seconds to turn on. Note the LED on the switch turns on as soon as the ON button in pressed long before the lights come on. Then, when I turn them off, the LED bulbs sometimes flicker on and off a half dozen times for about half a second. I also installed a PD-6ANS switch (single-pole) to operate 4 more identical bulbs in the kitchen with the exact same behavior. What is causing this delay? Is this a LED bulb compatibility issue? Currently, I'm using ECOSMART 5W 5000K (SKU 1001654247 Model 1003018602) bulbs. Unable to find these in the Lutron LED Compatibility Tool website nor am I able to locate the PD-5ANS or PD-6ANS to see what is compatible. To make matters confusing, I also installed a PD-6WCL dimmer that works perfectly with the same LED bulbs (6 bulbs) on the same circuit. Any help or advice would be greatly appreciated. Thanks in advance for everyone's time.
    Last edited by CRKinzie; 01-18-2021 at 04:58 PM. Reason: Wrong product code changed to correct code

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,076
    Make sure you have the neutral connected to the switch. Not all white wires are neutrals.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Senior Member
    Join Date
    Aug 2019
    Posts
    111
    May also want to test an incandescent bulb on the circuit to see how it performs. If it works well you may just need to add a LUT-MLC to the circuit with the LED's. https://www.lutron.com/TechnicalDocu...94_LUT-MLC.pdf

Similar Threads

  1. pd-5ans lights flash 3 times when using traveller to turn on
    By samsp99 in forum Troubleshooting - CAS
    Replies: 2
    Last Post: 09-01-2020, 09:51 AM
  2. Replies: 4
    Last Post: 05-28-2020, 08:31 PM
  3. PD-6ANS Lights don't come on
    By robzimm in forum Troubleshooting - CAS
    Replies: 3
    Last Post: 05-11-2020, 06:01 PM
  4. Lights blink continuously with new PD-6ANS
    By kbiglione in forum Troubleshooting - CAS
    Replies: 3
    Last Post: 04-12-2020, 12:28 AM
  5. PD-5ANS vs PD-6ANS
    By a4wanman in forum General Discussion - CAS
    Replies: 1
    Last Post: 11-27-2019, 04:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •