Hi all,Just got some new Caseta switches and ran into an issue installing them in a 2 gang box each controlling a single pole. The switches are currently wired with 3 black wires, with one pushed in the back on the bottom and the other in the bottom screw. It seems that the extra black wire connects the two switches. The ground wire is also a single one, which is wrapped around one switch's ground screw and continues on to terminate at the ground screw of the other switch. I am trying to install 2 Caseta switches (not dimmers). I've read on other posts that it is OK to connect the bottom two black wires, which are presumably the hot, to the black wire of the caseta switch. I also would then connect the neutrals to the bundle of neutrals that are capped off in the same box. But the main question is, is it also OK to connect the green wires from the 2 Casetas with the ground wire with one wire nut?Thanks for your help!